News

How do manufacturers make OF cable connectors and terminals?

      When making optical fiber cable, the core and outer skin of the cable are important. Optical fiber cable manufacturers should pay more attention to the joint and terminal position. We will explain some of the precautions for you.

      When fabricating metal shields or metal sleeves and armor layers at the ends of three-core power cable joints, optical fiber cable manufacturers must ensure that they are well connected and cannot be interrupted. The cross-section of the jumper should not be less than the relevant standards. In order to ensure the service life of the cable, the buried cable joint and the metal sheath of the metal casing and cable should be fully protected against corrosion. The terminal metal layer of the three-core cable should be grounded, the copper shield of the plastic cable and the steel wire should be soldered to the ground wire.

      When assembling and assembling the joints and terminals of the cable, the fitting and overlapping of the components shall be protected against moisture, plugging and sealing. When sealing the lead-clad cable, pay attention to wiping off the oxide on the surface. Too long, the seal should be tight and free of pores. The oil-filled cable also needs to be sealed. The lead sealing process is divided into two parts. One is mainly to block the oil, the second is formed and strengthened, and the high-position lead seal can be reinforced with epoxy resin.